Use this procedure to start Novapoint Base:
MOUS_ICO Double-click desktop icon
MOUS_ICO Click Start > All Programs > Novapoint Base[version]
You may launch CAD, with Novapoint design modules, from Novapoint Base.
Find it here:
MOUS_ICO In Status bar, at rightmost position, see illustration
MOUS_ICO Click on “Not started” and CAD will launch
Use this procedure to make CAD always and automatically start together with Novapoint Base.
1. Click the arrow on the CAD launch button, see above
2. Check “Autostart CAD with Novapoint Base”
Use this procedure to make Novapoint Base close automatically if CAD is closed:
1. Click the arrow on the same button as you loaded CAD from, see above.
2. Check “Automatically close Novapoint Base when CAD is closed”
NB! It may take a few seconds before Novapoint Base closes down.
