PDF Export RSS - Latest News

Configure GeoSuite for AutoCAD/Civil3D 15.2

Trimble Novapoint GeoSuite Toolbox supports AutoCAD/Civil3D 2017, but for the moment this is not supported by the installation program. (up to version 15.2.2)

To use these Autodesk products in GeoSuite Toolbox You have to perform a manual configuration.

Before we start - check the properties for the shortcut You will use to start AutoCAD/Civil3D. Look for the path and filename to start AutoCAD/Civil3D - compare the picture below…

After installation of GeoSuite Toolbox - perform tha manual configuration by following these steps:

  1. Open GeoSuite Toolbox and choose Settings→Configuration file
  2. Look for section [SYSTEM]
  3. There is a number of parameters that should be set for use of AutoCAD/Civil3D
  4. Set the parameters shown below to corresponding values of Your AutoCAD/Civil3D installation:
  5. ACADEXEA=“C:\Program Files\Autodesk\AutoCAD 2017\acad.exe”
  6. ACADEXE=“C:\Program Files\Autodesk\AutoCAD 2017\acad.exe”
  7. ACADOPT=/ld “C:\Program Files\Autodesk\AutoCAD 2017\\AecBase.dbx” /p “«C3D_Metric»” /product “C3D” /language “en-US”
  8. ACADVER=21
  9. Save and restart GeoSuite Toolbox
  10. Check the properties of the shortcut for GeoSuite Toolbox. Make sure there is a parameter at the end of the command set to /ACAD=20. (NOTE! It should be 20 in the shortcut, but 21 in the settings file!)

Shortcut to AutoCAD/Civil3D:

“C:\Program Files\Autodesk\AutoCAD 2017\acad.exe”

Shortcut to GeoSuite:

en/np/geotechnics/faq/geosuite_installation/acad2017_in_gs15_2_2.txt · Last modified: 2017/02/15 13:06 by gs_se_jln