Release date: 02.05.2016
Links: Base | Road | Railway |Area Planning | Landscape | Terrain Design | Noise | Bridge Design | Tunnel | Water & Sewer | District Heating | Road Signs | Road Marking | Land Acquisition Planner | Virtual Map | Reinforcement | Civil Construction | Feature Catalog 1903 1.04 | Geotechnics | Easy Access |
One could borrow license but DCM Basic failed even though it looked as if one had borrowed license. The problem is now resolved.
FIXED: Alignment Design could hang when an alingment was stored to a task without a calculation basis.
FIXED: Some road models hung on calculation of terrain profiles (step 1).
FIXED: Inserting edge for the pavement gave a inner slope going across the cross-section in the Cross-section Viewer. This is now fixed for use of Insert Edge on the median, but not on ex. medians between the carriageway and a separate bikepath/walkpath.
The error in itself should not affect the mass calculation or result features since it is only visible in the Cross-section Viewer.
FIXED: Errors on quantity calculation in FP3 for volumes of the road pavement and area of road bed/formation.
=== Draw Longitudinal profile IMPROVED/FIXED: Ground surface and Sub-surface layers is cut by the profile inner frame so it does not draw over other data in the longitudinal profile.
FIXED: Longitudinal profiles now again shows linetype for Rock when rock is at ground surface.
=== Draw Cross-sections FIXED: Cross-section drawings was not always drawing with the illustration objekcts even though they were used. This applied to volume objects and alignments.
FIXED: Wrong surface edges in the XML-file for surface 4.1 and outwards.
NEW: It is now possible to define linear interpolated transition radius for both inner profile and perimeter.
FIXED: The geology- and rock support registration dialog crashed for some situations when you pressed Save or OK. This is now fixed.
FIXED: The 3D-drawing failed for some situations where you had changes in the road/railroad superstructure. This is now corrected.
FIXED: For some situations, the perimeter line was not drawn all the way in the plan drawing . This is now corrected.
FIXED: When choosing a drawing style with dotted inner profile line for the cross-section drawing, the inner profile was not drawn. This is now corrected.
FIXED: The volume annotation on the distance plan drawing was not shown. This is now corrected.
IMPROVED: Wrong behavior in toggle buttons. Some settings did not match the expected behavior.
