If you use Trimble Quadri, this version can only be used with Trimble Quadri 2.0 or newer.
If you use named login (Vianova ID) with Novapoint 20.05, then make sure you have Novapoint 20.05.FP4a
Models created with earlier versions of Novapoint, will be converted on opening in NP20.00 and can ONLY be used in NP20.00, and it will not be possible to open it with earlier versions of Novapoint after conversion.
Using Novapoint 20.05 with floating license (FLEXlm license manager) will require license manager 11.14 of FLEXlm. Make sure the license manager support this before you try to use Novapoint 20.05. If your network uses the IPv6 protocol (as used in Microsoft Direct Access), you should set the FNP_IP_PRIORITY=6 environment variable on the client computer to give priority to IPv6, which can improve performance and avoid unwanted IPv4 address resolution.
Novapoint 20.00 and Novapoint 20.05 will both require license version 20.00.
Login using named user (Vianova ID) will work for both Novapoint 20.00 and Novapoint 20.05.
There are some issues using the USB hardware lock (FLEXid). Please contact us if you want to use Novapoint 20.05 with the USB lock.
Release date: 17.08.2017
Links: Base | Road | Area Planning
Noise | Bridge Design | Tunnel | Water & Sewer | District Heating | Road Signs | Road Marking | Land Acquisition Planner | Virtual Map | Reinforcement | Civil Construction | Feature Catalog 1919 1.15 | Geotechnics | Easy Access | Transport Networks |
IMPROVED: This update contains general bug fixes and improvements.
NEW: Save as Task
Use the new tool Save as Task when you have an active temporary plan or 3D window you would like to save as a presentation. When Save as Task is pressed, either Plan-, or 3D-presentation task will open, depending on the active window. The task will be prefilled with the feature selection and drawing rule from the temporary window.
IMPROVEMENT: Sweep
The Settings dialog has been improved and it is now allowed to select all attributes regardless to attribute type. Also added is an automatic determination of outer or inner diameter based upon the material type. More info of Sweep function here
IMPROVED: Export to LandXML gave wrong values for “startSta” for vertical geometry that could be confusing for users. Results were still correct.
IMPROVED: Description and logic for reading and comparison of alignment from drawing against alignment found in the Quadri model.
CORRECTED: Crash in function when using trim/extend from CAD-functions.
CORRECTED: Overwrite of alternatives in specific workflows.
CORRECTED: Deep blasting comes and goes in some cases.
CORRECTED: Crossfall on deep blasting surface changed to abrupt in some cases.
IMPROVED: Does now draw with the vertical geometry.
CORRECTED: Instance where not all elements were draw as desired according to the drawing style.
CORRECTED: First and last chainage beneath the longitudinal profile part was missing.
CORRECTED: Widening did not always draw with widening values.
CORRECTED: Outer edge of vehicle was not correct for multi-jointed vehicles where these went wider than the pull-wagon.
CORRECTED: Crash when using Draw Tracks in NP20.05/CAD2017.
CORRECTED: Crash when selecting vertical from Terrain Elevation
NEW/IMPROVED: New functionality to simplify the surface for inner slope that continues along the terrain to the fill edge. In some cases this produced to many points in the cross-section for 3.party software to handle for machine controll equipment.
The functionality is found under Road Task > Design > Settings > Elements > Setting out > Simplify inner slope surface on terrain.
CORRECTED: Error in export report to TILOS.
CORRECTED: Error in the function in CAD 2017/NP20.05 resulted in a crash.
CORRECTED:
IMPROVED: Added opportunity to select which reference points and/or lines to draw.
